ProStart CT-5072 User's Guide download pdf (Page 5)

User guide P.5

WARNING: Engine runs until the pre-programmed run time expires.

6. The Parking lights will flash twice to indicate Ready mode is set.

Remotestarting

Press the button for approximately 1 second. The parking lights will turn ON to inform you that

the Remote Car Starter has received your signal. Approximately 5 seconds later, the engine will

start. The parking lights will remain ON during the pre-programmed run time of the engine.

If your vehicle does not start at the first attempt, the system will shut down, wait a few seconds and

try to start the engine again. There will be 3 start attempts before the system gives up.

DrivingOff

With the vehicle running remotely, press the button to disarm the starter kill (if installed) and

unlock the doors. Enter the vehicle and do the following:

1. Turn the ignition key to the IGNITION ON (RUN) position. (Do not turn the key to the CRANK

position while the engine is running. This would cause the starter motor to re-engage.)

2. Press the brake pedal to disengage the remote starter unit.

You are now ready to drive off.

Note: On some Push-To-Start (PTS) vehicles, no takeover is possible as pressing the brakes will

shut the engine down. Please talk to your technician to determine if the “Takeover mode” can be

set for your vehicle.

ArminganddisarmingoftheSystem

The Alarm can be configured by the installer either to Passive Mode (so as to arm automatically)

or Active Mode (so as to require the user’s intervention for arming). By default, the Remote Car

Starter is configured to Passive Mode.

Passive mode:

To arm the alarm, press the button on the transmitter, OR

1. In Passive Mode, the alarm will automatically arm 30sec once the last door is closed.

2. The LED on the antenna will flash quickly during the countdown preceding the activation

of the system.

3. Once the activation countdown expires, the siren will chirp once and the LED will flash

slowly to indicate that the alarm is now armed.

To disarm the alarm, press the

button on the transmitter.

1. The LED on the antenna will flash quickly during the countdown preceding the activation

of the system.

2. The alarm will automatically rearm itself after 30sec if no door is left opened (if the doors

are monitored) and the ignition is not turned ON.

Active Mode:

To arm the alarm, press the button on the transmitter.

1. The siren will chirp once.

2. The LED on the antenna will flash slowly.

To disarm the Alarm, press the

button on the transmitter.

1. The siren will chirp twice.

1 2 3 4 5 6 7 8 9 10 ... 13 14

Comments to this Manuals

No comments

ProStart CT-5072 User's Guide Page 5

Comments to this Manuals

Related products and manuals for Remote starters ProStart CT-5072