ProStart CT-5072 User's Guide

Browse online or download User's Guide for Remote starters ProStart CT-5072. ProStart CT-5072 User guide User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 14
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
INDUSTRY CANADA USER NOTICE:
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired operation of the
device.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that
the equivalent isotropically radiated power (EIRP) is not more than that required for successful
communication.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifications to this equipment. Such modifications could void the user's authority to operate the equipment.
Doc#: 110906 Rev:1.4 © 2011 -CT-5072- -FcN- Canada
ONE-WAY AUTOMATIC/MANUAL TRANSMISSION
REMOTE STARTER WITH FULL ALARM SYSTEM
AND VIRTUAL TACH SYSTEM
(AS PRG-1000 COMPATIBLE)
CT-5072
User Guide
WARNING !
It is the responsibility of the vehicle operator to ensure that their
vehicle is parked in a safe and responsible manner.
1. a) Manual transmission
: When leaving the vehicle, it is the user’s
responsibility to ensure that the gearshift lever is in the NEUTRAL
position and the parking brake is engaged in order to avoid accidents
upon remote starting.
b) Automatic transmission: When leaving the vehicle, it is the user’s
responsibility to ensure that the gearshift lever is in “Park” in order to
avoid accidents upon remote starting.
(Note: Make sure that the automatic vehicle cannot start in "Drive".)
2. It is the user's responsibility to ensure that the remote starter is
disabled or put into valet mode before servicing.
Page view 0
1 2 3 4 5 6 ... 13 14

Summary of Contents

Page 1 - CT-5072

INDUSTRY CANADA USER NOTICE: Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device

Page 2 - TABLE OF CONTENT

P.10 User Guide AdvancedFeatures:InstallationprogrammableOptionsThe Remote Car Starter was designed with flexibility and OEM integration in mind

Page 3 - UsingtheRemoteControl

User guide P.11 3. Exit the vehicle and close all doors, hood and trunk. 4. Press the button; this will lock the doors, arm the system alarm and

Page 4 - RemoteStartingYourVehicle

P.12 User Guide Siren to sound once after 10 sec. to warn the user that the vehicle was left unprotected. Pressing or will cancel this timer. Sh

Page 5 - DrivingOff

User guide P.13 Diagnostics–ParkingLightFlashTableParking lights flashes Description 1 • Doors locked. • Trunk released. • Start signal rec

Page 6 - RemoteStarterFeatures

P.14 User Guide PROSTARTLIMITEDLIFETIMEWARRANTYREMOTE STARTERS: As the manufacturer, DIRECTED ELECTRONICS, CANADA INC. (“Directed”) warrants to t

Page 7 - ValetMode

P.2 User Guide TABLE OF CONTENT INTRODUCTION WITH SMARTSTART™ ... 3USING

Page 8 - ColdWeatherMode

User guide P.3 IntroductionwithSmartStart™This is a state-of-the-art remote car starter system. The system is packed with advanced features such

Page 9 - TemporaryChirpDelete

P.4 User Guide VehiclePresetsHeaterWhen leaving the vehicle it is recommended to preset the accessory controls in preparation for the next remote

Page 10 - TurboMode

User guide P.5 WARNING: Engine runs until the pre-programmed run time expires. 6. The Parking lights will flash twice to indicate Ready mode is set.

Page 11 - SirenChirps

P.6 User Guide 2. The LED on the antenna will remain OFF. RemoteStarterFeaturesRemoteDoorLocksIf your system was installed with the Remote Doo

Page 12 - MultiCarOperation

User guide P.7 Note1: The engine will continue running until the user re-enters the vehicle or until the expiration of the run time. Note2: If the pr

Page 13 - User guide P.13

P.8 User Guide 2. Turn the key to the ON position. 3. Press the push-button switch until the Parking lights flash twice. 4. Release the push-butto

Page 14 - User Guide

User guide P.9 ExtendedRunTimeThis procedure can only be carried out once per remote start. While the vehicle is running remotely, pressing and re

Comments to this Manuals

No comments