P.2 http://www.autostart.ca Quick Installation Guide
ENTERING PROGRAMMING MODE
These are the programming buttons:
Complete step by step programming
1) Entering Programming Mode
2) Programming the transmitter to the module
3) Entering Programming Options
4) Programming the options
5) Adjusting the Horn/Siren output (if installed)
6) Setting up the TACH, VTS or Multi-speed Tach
PROGRAMMING THE TRANSMITTER TO THE MODULE
1. In programming mode (page 2) - the parking lights will stay on for up to 20 seconds.
2. Before the lights go out, turn the ignition key to OFF (if not OFF already), then ON, then OFF.
3. Press and hold the button and keep it down until the parking lights flash 5 times quickly.
4. The transmitter has been stored in memory. Each unit can store 4 remotes in its memory.
5. You have 20 more seconds to select one of the sub-menus if needed.
To program a transmitter on the second vehicle for multi-car operation;
press the button (instead of ) in step 3 of the transmitter association procedure.
ENTERING PROGRAMMING OPTIONS
1. In programming mode (page 2)
the parking lights will stay on for up to 20 seconds.
2. Before the lights go out, press and hold the brake pedal and then press one of the following buttons.
The Hood Pin
The Programming Button
(a.k.a. the P.B.)
The P.B. is located on the side of the module. This push button mimics the hood-pin switch
in order to avoid
having to get out of the vehicle to press the hood-pin switch. The P.B. will work only when the hood pin is
installed and the hood is up. (Ground on the hood line.)
Entering programming mode using the
Hood Pin
x Press and hold the hood pin down for 4 seconds.
x Release the hood pin.
The parking lights will turn ON for 1 second.
x While the parking lights are ON, press the hood pin once more and release immediately.
The parking lights will come ON solid for 20 seconds.
x You now have 20 sec. to select a submenu.
Note 1: To exit programming mode, close the hood.
Note 2: For vehicles that require the ignition to be turned ON to activate the brake circuit, follow these steps to
select a submenu:
x After flashing the hood pin, turn the ignition ON and wait for the parking lights to come ON
(4 seconds). Then, press the brake pedal to access the sub-menus.
(27 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals