ProStart CT-5072 Installation Guide download pdf (Page 15)

Installation Guide P. 15

Wire

Description

BLACK/

BROWN

(–)

Priority door

output only

Gives a negative pulse on the second press of the button.

YELLOW

(–)

Parking

Light output

500 mA negative Parking Light output

Note: Ensure that the voltage does not vary when the dimmer control

switch is turned up or down. If this is the case, you have selected the

wrong wire.

WARNING! There is also a positive Parking Light output. Only one of

these two outputs needs to be connected.

Auxiliary Relay

Fifth Relay Output

Remote car starters of this series are

equipped with an on-board high-

current programmable 5

relay that

can be used to power a second

ignition, accessory or crank wire. The

unit uses 3 sets of pins; each set

corresponds to a specific function of

the output. In order to activate one of

the three possible functions, you must

place the jumper (supplied) on one of

the three sets of pins and connect the

14 AWG wire to the second

IGN. / ACC. /

CRANK

wire of the vehicle.

Caution!

Only one set of pins can be used at one time. Using more than one jumper may result in serious

damage to the vehicle.

The relay output rating on this unit is 25A at most. Defective OEM solenoid switches can

sometimes draw up to 50 or 60a, causing the 30A fuse to blow. Always verify your circuit with an

appropriate measuring device.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 29 30

Comments to this Manuals

No comments

ProStart CT-5072 Installation Guide Page 15

Comments to this Manuals

Related products and manuals for Remote starters ProStart CT-5072