ProStart CT-5072 Installation Guide download pdf (Page 3)

Installation Guide P. 3

Introduction

This guide contains all the information relevant and necessary for the installation of the alarm and

remote starter system. Most of the features of this product are explained in the user guide.

Therefore, if you need detailed information about a feature of the product, we recommend that you

refer to the user guide.

Included in the Package

Please review the Installation Guide before beginning the installation, particularly the Wiring

Schematic and the Programming Options.

It is very important that you familiarize yourself with the programming and the operation of the

system, even if you have already installed a similar system in the past. There are many great

features that may be overlooked if the manual is not read; this would prevent you from maximizing

the potential of the Module.

Prior to the installation, make sure that all the hardware components required to install the system

are in the box.

The following is a list of components included in the kit:

1- Control unit

1- Plug in dual shock sensor

2- 4 button remote

1- Siren

1- Antenna and interconnect cable

1- Parts bag

1- Harness Kit

1- Wiring diagram

1- Relay and socket relay

1- User, Installation guide & Wiring diagram

Installation Tools

Here is a list of basic tools and supplies you will need to test and install safely.

• Digital Multi Meter (DMM), Computer safe logic probe, Fused jumper wire, Neon 'trouble' light

that is carpet safe, Fender protector, Carpet protector

• Soldering Iron, solder, electrical tape, wire tie straps, split loom, diodes, resistors, relays

• Wire cutters, Wire strippers, Wire crimpers, Needle Nose Pliers

• Sharp knife, Panel poppers, Various Screw drivers

• Socket set, Wrench set, Drill with Drill Bits, Coat hanger (for fishing wires through the fire

wall)

Installation Points to Remember

• On vehicles with a manual transmission, always ensure that all door pins are monitored by the remote

starter.

• Make sure that the Parking brake and Door switch contacts work properly.

• When working on a vehicle, always leave a window open.

• Never leave the keys in the car. Leave them on a workbench with a window rolled down.

• If possible, remove courtesy light fuse to prevent battery drain.

1 2 3 4 5 6 7 8 ... 29 30

No comments

ProStart CT-5072 Installation Guide Page 3