ProStart CT-5072 Installation Guide download pdf (Page 20)

P. 20 Installation Guide

4. Once the engine is running at normal idle speed, press the brake pedal and keep it

down until you hear the siren chirps 2 times.

Turn the Ignition OFF. At this point, the Tach setting has been programmed.

Note: The “Auto tach programming” can only be carried out once unless the system is reset.

Siren/Horn Timing Adjustment

Follow these steps to adjust siren/horn pulse timing:

1) Enter programming mode (page-17) - the parking lights will stay on for up to 20

seconds.

2) Press and hold the brake pedal, then simultaneously press the and START buttons

 the siren will chirp 5 times.

3) Release the brake pedal.

4) To change the timing:

a) To increase the pulse by 3 ms, press the

button.

b) To decrease the pulse by 3 ms, press the button.

c) To increase the pulse by 10 ms, press the button.

d) To decrease the pulse by 10 ms, press the button.

5) To save the new settings: press and . The siren/horn will chirp 3 times to

indicate that the settings have been successfully saved.

Setting the unit into Ready Mode

If the vehicle has a manual transmission

Please note that Ready Mode can be enabled by the remote or the handbrake, depending on the

option that was selected. Therefore, you must follow the appropriate procedure between the two

described below in order to set the vehicle into Ready Mode.

you must read the following indications. The unit must

first be set to Ready Mode in order to start the vehicle by remote. If the unit is not set to Ready

Mode, it cannot remote start the vehicle.

Once the system is set to Ready Mode, the vehicle can be remote started and stopped at any time.

The system will exit Ready Mode if a door, the hood or the trunk is opened, if the brake pedal is

pressed, if the parking brake is disengaged or if the ignition key is turned to the

IGNITION ON (RUN)

position.

To set the system to Ready Mode:

If Ready Mode is enabled by remote

If Ready Mode is enabled by handbrake

1. Ensure that all the doors, hood and trunk are closed. Make sure that the gear selector

is in the neutral position.

2. With the engine already running, apply

the parking brake once and release

the brake pedal.

2. With the engine already running, apply

the parking brake twice within 10sec.

Make sure to release the brake pedal.

The parking lights will flash 3 times

quickly and remain lit.

Skip to step 4.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 29 30

Comments to this Manuals

No comments

ProStart CT-5072 Installation Guide Page 20

Comments to this Manuals

Related products and manuals for Remote starters ProStart CT-5072