ProStart CT-3271 Installation Guide download pdf (Page 12)

p.12 CT-3271

12-Pin Accessories Harness

Wire

Description

BLUE (–)

AUX 3

(Trunk)

output

500 mA negative output. This output can be used to control Trunk

release (1-sec. pulse).

Note: AUX 3 (TRUNK) operates only when Ignition is OFF or when the

vehicle is running under remote control.

BROWN (–)

Lock

output

Programmable 500 mA, 7/10sec., or 4 sec negative outputs.

GREEN (–)

Unlock

output

Programmable 500 mA, 7/10sec., 4sec., or double 1/4 sec. pulse

negative output.

WHITE /

BROWN

(–)

Arm output

500 mA ground output when the button is pressed. This output is

activated 500 ms before the LOCK pulse and deactivated at the same

time as the LOCK pulse ends.

Note: The system will also give an ARM/REARM pulse on this wire

when it shuts down the vehicle after a remote start.

WHITE /

GREEN

(–)

Disarm

output

500 mA ground output when the button is pressed. This wire is for

disarming OEM Alarm systems.

Note: System will also give a DISARM pulse before remote start.

BLUE /

WHITE

(+)

Positive

Door input

This input should be used in vehicles that use a positive-switching

Dome Light circuit. Connect to a Dome Light wire testing +12 V with a

Door open.

CAUTION! You can only use either the NEGATIVE DOOR INPUT or

the POSITIVE DOOR INPUT wire. It is essential that the Module be

connected in such a way as to allow each one of the Doors to be

detected by the remote starter.

WHITE /

ORANGE

(–)

Starter Kill

output

The unit is equipped with a selectable passive- or active-arming Starter

Kill circuit that will immobilize the vehicle when the system is armed.

This wire will provide a constant 500-mA negative output when the

system is armed (locked by remote) or if remote started. This wire

should be connected to a Single Pole Double-Throw Relay (This wire

will connect to Pin 85, on the Relay, and Pin 86 will be connected to the

Ignition wire).

A second benefit of the Starter Kill is the Anti-Grind feature. When the

vehicle has been remote started the Anti-Grind prevents the starter

motor from re-engaging when the ignition key is inserted in the Ignition

switch and accidentally turned to the CRANK position (The Starter Kill

output becomes active during remote starts).

ORANGE

(–) Parking

Brake

input

This input is for manual transmission vehicle ONLY. It is used in the

Ready Mode sequence and must be connected. The Parking Brake

input must be given a ground signal (-) when the Parking Brakes are

applied.

PURPLE

(–)

External

Trigger

input

The External Trigger wire can be used for remote-starting/ stopping the

vehicle with an external device. When the vehicle is running, triggering

this input will also activate Idle Mode.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 26 27

Comments to this Manuals

No comments

ProStart CT-3271 Installation Guide Page 12

Comments to this Manuals

Related products and manuals for Remote starters ProStart CT-3271