ProStart CT-3271 Installation Guide download pdf (Page 17)

CT-3271 p.17

Note: For vehicles that require the ignition to be turned ON to activate the brake, follow these

steps:

a. After flashing the hood, turn the ignition ON; The parking lights will turn OFF

b. After 4 seconds the parking lights will turn ON and then press the brake.

Transmitter Programming Procedure

1. Enter programming mode (page-16) the parking lights will stay on for up to 20 seconds.

2. Before the lights go out, turn the ignition key to the IGNITION ON (RUN) position and

immediately to the OFF position.

3. Press and hold the BUTTON

and keep it down until the parking lights flash 5 times quickly.

4. The transmitter has been stored in memory.

Note: Each unit can store 4 remotes in its memory.

Entering Programming Options

1. Enter programming mode (page-16)  the parking lights will stay on for up to 20 seconds.

2. Before the lights go out, press and hold the brake pedal and then press one of the following

buttons:

BUTTON

................. to access mode 1;

BUTTON

................ to access mode 2;

3. The parking lights will flash once or twice to confirm entry into a mode.

4. Release the brake pedal.

Once the desired mode has been selected, the unit will fall (by default) into function #1 of that

mode; you can now select the option you want in function 1. Once this option has been chosen,

the parking lights will flash one, two or three to confirm your chosen option. You can not jump

over the Function! The unit will move on to function 2 of the mode selected, and so on.

BUTTON ------------------- for ------------------ Option 1,

BUTTON

------------------- for ------------------ Option 2,

BUTTON

& ----------- for ------------------ Option 3;

Programming option

Please refer to the Quick Installation Guide for more information on programming options.

Virtual tach system

Virtual Tach System combines the latest microcontroller technology and a complex algorithm that

took years to develop. VTS is able to effectively monitor the engine starting sequence and release

the starter at the right time without physically connecting the tach wire to the remote starter. The

VTS constantly monitors the data and readjusts itself automatically in order to maximize its

capability to start the engine properly in any weather or deteriorating battery condition

Note: Virtual Tach System is only available in automatic transmission.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 26 27

No comments

ProStart CT-3271 Installation Guide Page 17