ProStart CT-3271 Installation Guide download pdf (Page 19)

CT-3271 p.19

Auto Tach Programming Procedure

This process can be carried out instead of the conventional Tach Programming Procedure.

1. Make sure all the connections are done properly and that the Module has been

powered-up.

2. With the Hood up (Ground on the Hood Pin line), start the vehicle using the key.

3. Start up the engine and allow the vehicle to reach regular engine idle speed.

4. Once the engine is running at normal idle speed, press the brake pedal and keep it

down until you hear the parking lights output click 5 times.

5. Turn the Ignition OFF. At this point, the Tach setting has been programmed.

Note: The “Auto tach programming” can only be carried out once unless the system is reset.

Setting the Unit into Ready Mode

If your vehicle has a manual transmission you must read the following indications. The unit must

first be set to Ready Mode in order to start the vehicle by remote. If the unit is not set to Ready

Mode, it cannot remote start the vehicle.

Please note that Ready Mode can be enabled by the remote or the handbrake, depending on the

option that was selected by your installer. Therefore, you must follow the appropriate procedure

between the two described below in order to set your vehicle into Ready Mode.

Once the system is set to Ready Mode, the vehicle can be remote started and stopped at any time.

The system will exit Ready Mode if a door, the hood or the trunk is opened, if the brake pedal is

pressed, if the parking brake is disengaged or if the ignition key is turned to the IGNITION ON

(RUN) position.

To set the system to Ready Mode:

If Ready Mode is enabled by remote

If Ready Mode is enabled by handbrake

1. Ensure that all the doors, hood and trunk are closed. Make sure that the gear selector

is in the neutral position.

2. With the engine already running, apply

the parking brake once and release

the brake pedal.

2. With the engine already running, apply

the parking brake twice within 10sec.

Make sure to release the brake pedal.

The parking lights will flash 3 times

quickly and remain lit.

Skip to step 4.

3. Within 20 sec. of engaging the parking

brake, press and hold on the

transmitter.

The parking lights will flash 3 times

quickly and remain lit.

Remove the key: the engine will continue running.

5. Exit the vehicle and close all doors, hood and trunk.

6. Press . The parking lights will flash 2 times to confirm ready mode activation.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 25 26 27

Comments to this Manuals

No comments

ProStart CT-3271 Installation Guide Page 19

Comments to this Manuals

Related products and manuals for Remote starters ProStart CT-3271