ProStart CT-3271 Installation Guide download pdf (Page 14)

p.14 CT-3271

3-pin Harness

Wire

Description

GRAY/ LIGHT

BLUE

N/A

BLUE / WHITE

(–)

Horn output

500mA negative Horn output.

YELLOW /

WHITE

(–)

Parking lights

output

500 mA negative Parking Light output

Note: Ensure that the voltage does not vary when the dimmer control

switch is turned up or down. If this is the case, you have selected the

wrong wire.

WARNING! There is also a positive Parking Light output. Only one of

these two different outputs needs to be connected.

Auxiliary Relay

Fifth Relay Output (2nd IGN, ACC or CRANK)

Remote car starters of this series are

equipped with an on-board high-current

programmable 5

relay that can be used to

power a second ignition, accessory or crank

wire. The unit uses 3 sets of pins; each set

corresponds to a specific function of the

output. In order to activate one of the three

possible functions, you must place the

jumper (supplied) on one of the three sets of

pins and connect the 14 AWG wire to the

second IGN. / ACC. / CRANK wire of the

vehicle.

Caution! Only one set of pins can be used at one time. Using more than one jumper may result in

serious damage to the vehicle.

The relay output rating on this unit is 25A at most. Defective oem solenoid switches can sometimes

draw up to 50 or 60a, causing the 30A fuse to blow. Always verify your circuit with an appropriate

measuring device.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 26 27

No comments

ProStart CT-3271 Installation Guide Page 14