ProStart CT-3371 Installation Guide download pdf (Page 15)

Installation guide P.15

3pinHarness

Wire Description

GRAY/ LIGHT

BLUE

N/A

BLUE / WHITE

(–)

AUX 1 Output

Programmable 500 mA negative output.

YELLOW /

WHITE

(–)

Parking lights

output

500 mA negative Parking Light output

Note: Ensure that the voltage does not vary when the dimmer control

switch is turned up or down. If this is the case, you have selected the

wrong wire.

WARNING! There is also a positive Parking Light output. Only one of

these two different outputs needs to be connected.

AuxiliaryRelay

FifthRelayOutput(2ndIGN,ACCorCRANK)

Remote car starters of this series

are equipped with an on-board

high-current programmable 5

relay that can be used to power a

second ignition, accessory or crank

wire. The unit uses 3 sets of pins;

each set corresponds to a specific

function of the output. In order to

activate one of the three possible

functions, you must place the

jumper (supplied) on one of the

three sets of pins and connect the

14 AWG wire to the second IGN. /

ACC. / CRANK wire of the vehicle.

Caution!

Only one set of pins can be used at one time. Using more than one jumper may result in serious

damage to the vehicle.

The relay output rating on this unit is 25A at most. Defective OEM solenoid switches can

sometimes draw up to 50 or 60a, causing the 30A fuse to blow. Always verify your circuit with an

appropriate measuring device.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 29 30

Comments to this Manuals

No comments

ProStart CT-3371 Installation Guide Page 15

Comments to this Manuals

Related products and manuals for Remote starters ProStart CT-3371